Skip to main content
Version: 1.7

Autoterm Baltica Heating System

A Sensa heater controller puts your Autoterm Baltica system on the Climate tab, so you can switch it on and off and choose between hot water only, or hot water and heating.

Included in Pro and Vision.

How it connects​

Wi-Fi. The Sensa controller is a small box that plugs in behind the Baltica Control panel, between the panel and the heater, and takes its power from the panel cable. Your Baltica panel stays plugged into the box and keeps working.

Join your Wi-Fi​

Your controller arrives with its firmware installed. To put it on your van's Wi-Fi:

  1. On your phone, join the Wi-Fi network named ss-setup-baltic. The password is sensasetup.
  2. Pick your van's Wi-Fi network from the list and enter its password.
  3. Power the controller off and on again. It then joins your network.

Add to Sensa Nomad​

Once it is on your van's network, Sensa finds it on its own. Open Settings, choose the Devices tab, tick it under Discovered and press Add Selected Devices. If it is not there yet, press Scan.

See Adding devices for more.

What you see​

A heater card on the Climate tab with a power button and two mode buttons, Hot water and Water+Heat (hot water and heating), with the one in use lit. The coolant temperature shows as Now.

Good to know​

  • Change mode only from fully off. The Baltica cannot go straight from hot water only to hot water and heating. Switch it off, wait for it to finish cooling down (5 to 6 minutes), then pick the mode. The card tells you while it is busy.
  • The water temperature is fixed. The heater stops at 88 °C and restarts at 70 °C, using its own coolant sensor. You cannot change this, for safety on a pressurised system.
  • The room temperature stays on the Baltica panel. The heating target, hot water timer and circulation pump are set on the Baltica's own panel, not from Sensa.