Configure Router

Sensa can set up your Teltonika router for you, with separate networks for your own devices, smart devices, cameras and guests. If you have a different router, skip to Configure Core.

See Our best practice setup for what you end up with, and why.

1. Add your router to Sensa

Open Settings and choose the Devices tab. Tick your router under Discovered and press Add Selected Devices. If it is not there yet, press Scan.

2. Enter its password

Tap the cog on your router's row and enter the admin password you chose when you installed the router. Press Save, and Config Network opens.

3. Check what will change

Config Network reads your router and lists what it would add or change. Tell it how many wired devices each network has, so that it can plan which of the router's sockets each network uses.

Nothing changes on your router until you press Fix.

4. Press Fix

Type a password for each new Wi-Fi network, then press Fix.

Sensa takes a copy of your router's settings first, and puts it back if anything goes wrong. It also gives your Core a fixed address. Your router then restarts, which takes a few minutes.

5. Reconnect your tablet

If a Wi-Fi network was renamed, your Core rejoins it by itself, but your tablet and phone do not. Config Network tells you which Wi-Fi to reconnect to before you press Fix.

What to do next

Go on to Configure Core. Smart devices now belong on the IOT network, so change the Subnet next to the Scan button to 192.168.2.0/24 when you look for them.

For everything else on this screen, including the router diagram and managed switches, see Config Network.