Configure Starlink
If you do not have Starlink, skip to Install your router.
Starlink needs two settings changed in the Starlink app before it will work with a new router. Make both changes before you fit the router.
1. Change Starlink's address range
Starlink's router uses addresses starting 192.168.1 by default. Many routers, including the Teltonika routers from the Sensa shop, use the same range, and two devices on one range will not work together.
If you are installing a new router that uses 192.168.1, change Starlink's range to 192.168.3:
- Open the Starlink app and connect to your Starlink.
- Go to Settings, Router, Advanced.
- Change the address range to 192.168.3.0/24 and save.
2. Turn on Bypass Mode, if the dish plugs straight into your router
If you connect your dish to your new router with an Ethernet cable, rather than through Starlink's own router, turn on Bypass Mode in the Starlink app, under Settings, Router. Your new router then takes over the network and the Wi-Fi, and Starlink's own Wi-Fi switches off.
What to do next
Now install your router. For what Sensa shows about your dish, see Starlink.