Autoterm Air 9D Diesel Heater

A Sensa heater controller made for the Air 9D puts your heater on the Climate tab, so you can switch it on, pick a mode and set how warm you want the van.

Included in Pro and Vision.

Sensa Connection Method

Network: Wi-Fi.

Installation

The Sensa controller is a small box that plugs in behind the heater's control panel, between the panel and the heater, and takes its power from the heater's own panel cable. Your Autoterm panel stays plugged into the box and keeps working exactly as before, so you can still use it if Sensa is not running.

The Air 9D has its own controller, separate from the one for the Air 2D and 4D. Order the 9D version.

Configuration

Join your Wi-Fi

Your controller arrives with its firmware installed. To put it on your van's Wi-Fi:

1. On your phone, join the Wi-Fi network named ss-setup-airdh. The password is sensasetup.
2. Pick your van's Wi-Fi network from the list and enter its password.
3. Power the controller off and on again. It then joins your network.

Adding to Sensa Nomad

Once it is on your van's network, Sensa finds it on its own. Open Settings, choose the Devices tab, tick it under Discovered and press Add Selected Devices. If it is not there yet, press Scan.

See Adding devices for more.

What you see

The same heater card as the Air 2D and 4D, at the top of the Climate tab, with a power button, a dial and Autoterm's own modes. Heating explains every control.

Good to know

• There is no Heater Model to set. The controller already knows it is on a 9D, so the readings, diesel figures and fault descriptions work as soon as it is added.
• Choose which thermometer it goes by in the temperature modes with Temperature Sensor Source on the heater's row on the Devices tab: the wall panel, the heater's air intake, or any temperature sensor in your van.